Small CNC: Difference between revisions
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
|founder=base48 | |founder=base48 | ||
|coops=[[User:Lubko|Lubko]] | |coops=[[User:Lubko|Lubko]] | ||
|status= | |status=active | ||
}} | }} | ||
Small CNC machine, good for [[PCB Milling]]. | Small CNC machine, good for [[PCB Milling]]. | ||
= Safety = | == Safety == | ||
* Emergency stop (E-stop) cuts power to motors, should be released only when milling is in progress | |||
* Debris and broken tool parts my go flying from the spindle. Wear eye protection when E-stop is released! | |||
= | == Parameters and Operation == | ||
* Three axis | |||
* Controlled by PC with LinuxCNC | |||
* Water cooled spindle | |||
== Useful GCodes == | |||
* '''G0 X0 Y0 F100''' -- Non-cutting move to X0 Y0 at 100mm/min, Z coordinate stays | |||
* '''G38.2 Z-5 F30''' -- Move Z up to -5mm at 30mm/min (slowly) until probe trips | |||
== Pictures == | |||
Feel free to upload pictures of your finished PCBs and add link(s) to following gallery: | Feel free to upload pictures of your finished PCBs and add link(s) to following gallery: | ||
Revision as of 13:57, 15 September 2026
Small CNC machine, good for PCB Milling.
Safety
- Emergency stop (E-stop) cuts power to motors, should be released only when milling is in progress
- Debris and broken tool parts my go flying from the spindle. Wear eye protection when E-stop is released!
Parameters and Operation
- Three axis
- Controlled by PC with LinuxCNC
- Water cooled spindle
Useful GCodes
- G0 X0 Y0 F100 -- Non-cutting move to X0 Y0 at 100mm/min, Z coordinate stays
- G38.2 Z-5 F30 -- Move Z up to -5mm at 30mm/min (slowly) until probe trips
Pictures
Feel free to upload pictures of your finished PCBs and add link(s) to following gallery:
