RackPrinter: Difference between revisions
imported>Rmarko (Init) |
imported>Rmarko m (minor, fix heading) |
||
| Line 18: | Line 18: | ||
* SSR | * SSR | ||
== Frame | == Frame == | ||
* 3030 alu from http://ehlinik.cz | * 3030 alu from http://ehlinik.cz | ||
* angle brackets | * angle brackets | ||
Revision as of 14:21, 16 July 2015
What
- Reliable workhorse mounted in 21U rack
Heated chamber
- http://reprap.org/wiki/Heated_Build_Chamber
- heat source (need 40-80°C, typical operating temperature seems to be 50°C)
- hair dryer
- hot air gun
- light source
- epic heatbed
- combination of the above
- SSR
- insulation
Heatbed bed
- custom size required
- SSR
Frame
- 3030 alu from http://ehlinik.cz
- angle brackets
- M6 hw
Motion
X/Y
- Alumimaker 2 style
- precision rods (M8?)
- precision bearings
- shafts
- gt2 belts
- need to sustain heated bed temperature
Z axis
- 4x M12 rods
- 4x LMK12LUU
- 4x SHF12 12mm shaft support
Extruder
- 2x bowden
- drive wheel has to be located outside of the heated chamber
- full metal
- dual drive wheel
Hotend
- dual or 2 separate X gantries
- Cyclops (90GBP), needs water cooling mod
- plastics
- ABS
- PLA
- PVA support
Shoplift
Frame
- 3030 alu from http://ehlinik.cz