PlotBot: Difference between revisions
No edit summary |
No edit summary |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{Project | Original project:{{Project | ||
|name=Base48 PlotBot | |name=Base48 PlotBot | ||
|image=20260119_145224.jpg | |image=20260119_145224.jpg | ||
|founder= | |founder=niklasroy.com/robotfactory | ||
|coops=lubko, vanicka | |coops=lubko, vanicka | ||
|status=active | |status=active | ||
| Line 11: | Line 11: | ||
https://www.niklasroy.com/robotfactory/ | https://www.niklasroy.com/robotfactory/ | ||
Cost: | |||
Material: | |||
3D print changes: | |||
Arduino code: | |||
=== Control Board === | |||
[[File:Turtle-bot-v3-pcb-back-etch.png|thumb|Traces can be drawn on copper laminate (cuprexit) with toner transfer technique and chemically etched. Negative printout for PCB etching: [https://github.com/lkundrak/turtle-robot/raw/refs/heads/main/artifacts/turtle-bot-v3-pcb-back-etch.pdf turtle-bot-v3-pcb-back-etch.pdf]]] | |||
Schematic: [https://github.com/lkundrak/turtle-robot/raw/refs/heads/main/artifacts/turtle-bot-v3-schematic.pdf turtle-bot-v3-schematic.pdf] | |||
Fabrication notes: [https://github.com/lkundrak/turtle-robot/raw/refs/heads/main/artifacts/turtle-bot-v3-pcb-fab-notes.pdf turtle-bot-v3-pcb-fab-notes.pdf] | |||
Negative printout for PCB etching: [https://github.com/lkundrak/turtle-robot/raw/refs/heads/main/artifacts/turtle-bot-v3-pcb-back-etch.pdf turtle-bot-v3-pcb-back-etch.pdf] | |||
Latest revision as of 20:37, 12 February 2026
Original project:
Base48 PlotBot
Founder:
niklasroy.com/robotfactory
Coops:
lubko, vanicka
Status:
active
https://hackaday.com/2025/09/02/this-plotter-knows-no-boundaries/
https://www.niklasroy.com/robotfactory/
Cost:
Material:
3D print changes:
Arduino code:
Control Board
Schematic: turtle-bot-v3-schematic.pdf
Fabrication notes: turtle-bot-v3-pcb-fab-notes.pdf
Negative printout for PCB etching: turtle-bot-v3-pcb-back-etch.pdf