ESP: Difference between revisions

From base48
imported>Rmarko
m (minor: note about pin16)
imported>Rmarko
(esplib, esphs)
 
(One intermediate revision by one other user not shown)
Line 5: Line 5:
* ESPtool with pre-build binaries https://git.48.io/esptool
* ESPtool with pre-build binaries https://git.48.io/esptool
* Luatool fork https://github.com/hackerspace/luatool
* Luatool fork https://github.com/hackerspace/luatool
* [[ESPLib]]
* Haskell management utilities https://git.48.io/esphs/


=== Boards ===
==== snajpa's ====
* https://github.com/snajpa/espboards
==== srk's ====


=== Flashing NodeMCU ===
=== Flashing NodeMCU ===

Latest revision as of 15:49, 3 August 2018

ESP8266

Boards

snajpa's

srk's

Flashing NodeMCU

<syntaxhighlight lang="bash">git clone https://git.48.io/esptool.git</syntaxhighlight>

  • add jumper to flash enable pins - isolated pin header with two pins GPIO0 and GND.
  • connect VCC and GND pins to 5V on USB serial converter
  • connect ESP RX/TX pins
  • try plugging in serial converter, led on the ESP should blink briefly
  • flash dev firmware (or debug firmware if needed)

<syntaxhighlight lang="bash">cd esptool ./flash_bin_dev</syntaxhighlight>

  • remove jumper
  • start terminal with 115200 baudrate

<syntaxhighlight lang="bash">miniterm.py /dev/ttyUSB0 115200</syntaxhighlight>

  • disconnect and re-connect power to ESP (preferably without disconnecting USB serial converter as you wouldn't see early boot messages)
  • NodeMCU should start
    • during first boot you should see Self adjusting flash size and Formatting filesystem messages
    • after formatting you should get NodeMCU prompt >



<syntaxhighlight lang="bash">Early boot

$ miniterm.py /dev/ttyUSB0 74880

Program

$ miniterm.py /dev/ttyUSB0 115200

sometimes

$ miniterm.py /dev/ttyUSB0 9600

Flashing custom build nodemcu

./esptool.py -b 921600 write_flash -fm dio 0x00000 bin/0x00000.bin 0x10000 bin/0x10000.bin


NodeMCU build

customization

app/include/user_config.h app/include/user_modules.h app/include/user_version.h</syntaxhighlight>


<syntaxhighlight lang="bash">triac_reg_pinout

0: GPIO16 (no pwm or interrupt!) 1: GPIO5 230 sense 2: GPIO4 triac out 3: GPIO0 (Special: Bootloader when low) 4: GPIO2 5: GPIO14 debug led 6: GPIO12 ws2812 4x4 array 7: GPIO13 8: GPIO15 RX: GPIO3 TX: GPIO1 A0:</syntaxhighlight>


<syntaxhighlight lang="bash">toggle(dir_pin)

slider_pinout

0: GPIO16 1: GPIO5 enable 2: GPIO4 direction 3: GPIO0 (Special: Bootloader when low) 4: GPIO2 debug led 5: GPIO14 step 6: GPIO12 ws2812 4x4 array 7: GPIO13 8: GPIO15 RX: GPIO3 TX: GPIO1 A0:</syntaxhighlight>